1、 Not deep:

1. If there is no problem in the above items, check whether the lens in the light outlet of the laser tube has scratches and dirt. If it is also normal, then it is exciting The quality of the light tube itself is a problem.

2. The light will not be deep for a while: first, check whether the supporting point of the laser tube is reasonable, whether the water temperature is more than 30 degrees, whether the lens is hot when working, whether the flow pressure of the cooling water is normal, whether the cooling water is clean, and then check the laser tube after the above is normal

2、 High voltage ignition and discharge: check whether there is dirt and moisture around the high-voltage head, and whether it is too close to the metal part of the machine; in addition, check whether the high-voltage connection device of the laser power supply falls off the support, and whether the internal wire of the high-voltage connection device is broken and damaged. If the above is normal, then it is the quality of the laser tube itself.

3、 The laser tube is broken, cracked and the water-cooling head falls off:

1. Whether the water temperature is controlled within the range of 25 ℃ - 30 ℃. The cooling water in cold areas shall not be frozen, especially after the laser is stopped, the cooling water shall not be stored in the laser tube.

2. Whether the lighting works under the control of water protection; (test whether the lighting will be on or off with the water)

3. Whether the water pipe of the waterway will be dismantled.

4. Whether there are bubbles in the laser tube.

5. Whether the water pressure flow is normal; whether the water flow direction is low in and high out.

If item 6.1-5 is normal, it is the quality problem of laser tube itself