In modern industry, the laser equipment needs to be debugged and maintained after a period of use to ensure normal operation, but how can the Suzhou laser cutting machine be debugged to be faster and better?

First of all, there are many laser equipment components, and some parts have shorter maintenance periods, which requires frequent maintenance to have a good running state, such as cutting speed and effect.

Adjust the laser cutting machine parameters to improve the cutting speed of the machine.

Machine parameter setting is one of the main reasons affecting the cutting speed of the machine. In general, if the parameters are not adjusted well, its cutting speed will not work. The parameters are like a series of actions related to a person driving, starting, accelerating, etc. If the parameters are not set, it is like when the car is starting and you hang in the second gear to start. When starting, It will have jitter. When adjusting this parameter, generally pay attention to the following points:

Initial speed

As the name implies, this setting is the speed at which the machine starts, which is like the speed at which the car is just starting when it is driving. Many customers have such a misunderstanding that the larger the initial speed, the better, but in fact this is wrong. If the initial speed of the laser cutting machine is set too high, the machine jitter will be very large.

2.Acceleration

Acceleration means the speed of the gas pedal during the drive of the car. It is the time from the initial speed to the normal cutting of the machine. Laser cutting machine is a process of starting and stopping continuously when cutting different patterns. Setting the acceleration too low will cause the machine to cut slowly.

Second, adjust the machine assembly to improve the cutting effect of the machine.

1.rail mounting

The installation of the guide rail should be parallel. If the installation is not parallel, there will be resistance when the laser cutting machine runs, it will be stuck when walking, and there will be sawtooth when cutting. Therefore, the installation of two parallel rails in the Y direction is only possible with two parallel lines, and there must be no error between them.

2. The installation position of the beam and the coupling is not good

When the machine beams and couplings are installed, the reed wire is not locked, or when it is locked, it is oblique, and so on, and this will happen.